STMicroelectronics P-NUCLEO-IOM01M1 STM32 Nucleo Pack

STMicroelectronics P-NUCLEO-IOM01M1 STM32 Nucleo Pack is composed of the STEVAL-IOM001V1 and the NUCLEO-F446RE board. The STEVAL-IOM001V1 is a single IO-Link master PHY layer (L6360), while the NUCLEO- F446RE runs an IO-Link stack rev 1.1 (developed by and property of TEConcept GmbH, license limited to 10k minutes, renewable without additional costs). The STM32 Nucleo pack is an easy-to-use solution to evaluate IO-Link applications, L6360 communication features and robustness, and STM32F446RET6 computation performance. STMicroelectronics P-NUCLEO-IOM01M1 STM32 Nucleo Pack, hosting up to four STEVAL-IOM001V1 to build a quad port IO-Link master, can access the IO-Link physical layer and communicate with IO-Link Devices. Evaluate the tool via the dedicated GUI (IO-Link Control Tool©, propriety of TEConcept GmbH) or use it as an IO-Link master bridge. This is accessible from the dedicated SPI interface, source code of demo project (Low-Level IO-Link Master Access developed by TEConcept GmbH), available for free.

Features

STEVAL-IOM001V1
- IO-Link master PHY based on L6360
- Interrupt diagnostics pin
- I²C and UART interface
- SPI (slave) interface
- 65mA selectable (3.3V or 5.0V) linear regulator
- CQ (push-pull) and L+ (high side) switches
- IQ additional IEC61131-2 type 1 digital input
- L+ and CQ overload and overheating protections with non-dissipative cut-off function
- QFN-26L (3.5mm x 5mm x 1mm) package
- Operating voltage range from 18V to 32.5V
- Additional high side switch for L+ heavy loads (IPS161H)
- LEDs for status and diagnostics
- Ground and VCC wire break protections
- EMC compliance with IEC61000-4-2, IEC61000-4-3, IEC61000-4-5
- Equipped with ST morpho connectors
- CE certified
- RoHS and China RoHS compliant

NUCLEO-F446RE
- STM32F446RET6 32-bit Micro-controller based on ARM®Cortex®-M4 core (180MHz max.) with 512-KB Flash memory and 128(+4)KB RAM
- Two types of extension resources: Arduino™ UNO Revision 3 connectivity and ST morpho extension pin headers for full access to all STM32 I/Os
- Mbed-enabled (http://mbed.org)
- On-board ST-LINK/V2-1 debugger/programmer with SWD connector and a selection-mode switch to use the kit as a standalone ST-LINK/V2-1
- USER and RESET push-buttons